IP camera Mobotix

This type of cameras is used in case the video flow should be taken from Mobotix IP-cameras.

To select and configure Mobotix IP-cameras as the data source, one must perform consistently the following steps (see figure Channel settings. Selection and configuration of Mobotix IP-camera as the video source):

1. select source type-IP-camera;
2. select type of the camera- Mobotix;
3. configure the video flow transmission parameters.

Channel settings. Selection and configuration of Mobotix IP-camera as the video source

IP address - in this field you must enter the IP-address of the camera, in the format xxx.xxx.xxx.xxx:xxxx, where up to ':' - it's just IP-address of the camera, and after - the port number.

Fields Login, Password, Camera Number, Profile and Protocol shall not be filled for this type of cameras. This type of cameras does not have the option to control the camera.

Resolution. This field is to select the necessary resolution. Raising the resolution in direct ratio affects the quality of recognition, and inversely affects the velocity of data transmission For Mobotix Ip-cameras the following types of resolutions are available: 160 * 120 320 * 240 640 * 480, 1280x960, 2048 * 1536.

Compression. This field specifies the necessary compression, JPEG and MhPEG formats are being supported for Mobotix Ip-cameras.

Compression level. This filed allows you to select the necessary compression level. Raising compression level inversely affects quality of recognition and in direct ratio affects the velocity of the data transmission. Valid values are: from 1 to 100.