|
|
| Line 1: |
Line 1: |
| − | This type of cameras is used in case the video flow should be taken from Axis IP-cameras.
| + | Importing file |
| − | | |
| − | <br />
| |
| − | To select and configure Axis IP-camera as the data source, one must perform consistently the following steps (see figure ''Channel settings. Selection and configuration of Axis IP-camera as the video source''):
| |
| − | <br />
| |
| − | # select source type - IP-camera;
| |
| − | # select type of the camera - Axis;
| |
| − | # configure the video flow transmission parameters.
| |
| − | | |
| − | <br/>
| |
| − | [[File:OverseerParkingEng12.png|thumb|center|Channel settings. Selection and configuration of Axis IP-camera as the video source| 900px]]
| |
| − | <br/>
| |
| − | | |
| − | When Axis IP-camera is selected as the video source, the video stream transmission parameters can be set for it.
| |
| − | | |
| − | <br />
| |
| − | '''IP address'''. Enter the IP-address of the camera into this field in format ххх.ххх.ххх.ххх:хххх. Enter the IP-address of the camera before “:” and after this symbol enter the number of the port. Also, entering for this type of camera is possible in format www.xxxxx.xхx:xxxx, where before “:” state URL of the camera, and after “:” enter the number of port.
| |
| − | | |
| − | <br />
| |
| − | '''Login and password'''. In these fields login and password should be entered for access to the IP-camera. They may be required both for observation and camera management.
| |
| − | | |
| − | <br />
| |
| − | '''Camera’s number'''. If IP-coder with one or more connected cameras is used, then state in this field number of the camera, video flow from which should be processed.
| |
| − | | |
| − | <br />
| |
| − | '''Profile and Resolution''' fields do not have to be filled. Camera settings are being used for this type of cameras.
| |
| − | | |
| − | <br />
| |
| − | '''Compression'''. In this field state required compression. M-JPEG, MPEG-4 and Н.264 formats are being supported for Axis IP-cameras.
| |
| − | | |
| − | <br />
| |
| − | '''Protocol'''. This field is for choosing the data transfer protocol. HTTP, MCUST, HTTPS, RTSP protocols are supported for Axis IP-cameras.
| |
| − | | |
| − | <br />
| |
| − | '''Camera control'''. This setting turns on management of the IP-camera.
| |
